
Peel-off Orange

The Orange is modelled as an ellipsoid, so that the shape of the orange
can be controlled by increasing/decreasing the radius in the x-, y- and
z- directions.

The peeling of an orange can be viewed by pressing the 'u' key (UP) to
peel-off more of the orange skin, and 'd' key (DOWN) to view the orange
with lesser peeled off skin.

Animation of the scene is controlled with the 'a' key (begins/stop
animation) and UP, DOWN, LEFT and RIGHT arrow keys to control the speed of
rotation about the x- and y- axes.

The Controls are more fully described below:

-   Press 'm' to Move the figure down
-   Press 'M' to Move the figure up
-   Press 'u' to peel off the orange more
-   Press 'd' to peel off the orange lesser
-   Press 'x' to decrease the X-Radius
-   Press 'X' to increase the X-Radius
-   Press 'y' to decrease the Y-Radius
-   Press 'Y' to increase the Y-Radius
-   Press 'z' to decrease the Z-Radius
-   Press 'Z' to increase the Z-Radius

-   Press "W" to increase the number wraps.
-   Press "w" to decrease the number wraps.
-   Press "N" to increase the number of segments per wrap.
-   Press "n" to decrease the number of segments per wrap.
-   Press "q" to toggle between quadrangles and triangles.

-   Press the "a" key to toggle the animation off and on.
-   Press the "s" key to perform a single step of the animation.
-   The left and right arrow keys controls the
		rate of rotation around the y-axis.
-   The up and down arrow keys increase and decrease the rate of
		rotation around the x-axis.  In order to reverse
		rotational direction you must zero or reset the
		torus ("0" or "r").
-   Press the "r" key to reset the orange back to the initial
-		position, with no rotation.
-   Press "0" (zero) to zero the rotation rates.
-   Pressing "p" toggles between wireframe and polygon mode.
-   Press '1' to toggle on/off the 1st light (It is recommended NOT
    to switch off the light)
-   Press '2' to toggle on/off the 2nd light (again recommended NOT
    to switch off the light)


